Pioneer VSX-819H-S 08Using the tuner, Changing the frequency step, Listening to station presets

08Using the tuner

3Press PRESET / to select the station preset you want.

You can also use the number buttons.

4Press ENTER.

After pressing ENTER, the preset number stop blinking and the receiver stores the station.

Listening to station presets

You will need to have some presets stored to do this. See Saving station presets on page 49 if you haven’t done this already.

•Press PRESET / to select the station preset you want.

•You can also use the number buttons on the remote control to recall the station preset.

Naming preset stations

For easier identification, you can name all of your preset stations.

1Choose the station preset you want to name.

See Listening to station presets above for how to do this.

2Press TUNER EDIT twice.

The cursor at the first character position is blinking on the display.

3 Input the name you want.

Choose a name up to eight characters long.

•Use the PRESET / buttons to select character position.

•Use the TUNE / buttons to select characters.

•The name is stored when ENTER is pressed.

Tip

•To erase a station name, follow steps 1 and 2, and press ENTER while the display is blank. Press TUNER EDIT while the display is blank, to keep the previous name.

50

•Once you have named a station preset, press DISPLAY to show the name. When

you want to return to the frequency display, press DISPLAY several times to show the frequency.

Changing the frequency step

If you find that you can’t tune into stations successfully, the frequency step may not be suitable for your country/region. Here’s how to switch the setting:

1Switch the receiver into standby.

2While holding down the ‘TUNE –’ button, press and hold the  STANDBY/ON button for about two seconds.

The channel tuning step alternates between 10K STEP and 9K STEP each time you do this.

En