Fine Tuning Your Surround Sound
SUBWF 100 Hz
Sends bass frequencies below 100 Hz to the subwoofer.
SUBWF PLS
Adds extra bass to the soundtrack.
SUBWF – – –
Select if you didn’t connect a subwoofer.
Press SETUP to advance to the next receiver setting mode.
Press ENTER if you want to exit the setting mode.
•The Subwoofer setting will appear automatically, depending on whether you have connected a subwoofer or not.
•The default setting is “200 Hz”.
•You can only select PLS when the front speakers are set to Large (L).
•If the all the speakers are set to Large (L) you can only select 100 kHz, PLS or off (– –
•Setting the front speakers to Small (S) means you will use a subwoofer, thus its setting cannot be turned off. In this case make sure you set the subwoofer and choose its cutoff frequency.
•There are some cases where no sound will come from the subwoofer even if it is (this depends on the speaker setting, the listening mode and/or the kind of source material).
Front speakers distance setting
Set the distance from the front speakers to the listening position.
Follow steps 1&2 on page 29 (if necessary).
Use the +/– buttons to choose the distance of the front speakers from the main listening position (within a range from 1 foot [0.3m] to 30 feet [9m]).
Press SETUP to advance to the next receiver setting mode.
Press ENTER if you want to exit the setting mode.
•The default setting is “6 feet (1.8m)”.
•One step equals about 1 foot (0.3m).
•If you do the Room Setup (see page 28) after the settings here, those will take precedence.
Center speaker distance setting
Set the distance from the center speakers to the listening position.
Follow steps 1&2 on page 29 (if necessary).
Use the +/– buttons to choose the distance of the center speaker from the main listening position (within a range from 1 foot [0.3m] to 30 feet [9m]).
English
LFE attenuator setting | Press SETUP to advance to the next receiver setting mode. | |
Dolby Digital and DTS audio sources include | Press ENTER if you want to exit the setting | |
mode. | ||
bass tones. Set the LFE attenuator as needed to prevent | ||
| ||
the |
| |
all the active speakers. |
|
Follow steps 1&2 on page 29 (if necessary).
Use the +/– buttons to choose the attenuation level 0 dB, 10 dB or LFE OFF.
0 dB
No attenuation.
10 dB
LFE volume is reduced.
LFE OFF
LFE channel is off.
Press SETUP to advance to the next receiver setting mode.
Press ENTER if you want to exit the setting mode.
•The default setting is “5 feet (1.5m)”.
•One step equals about 1 foot (0.3m).
•When “CENTER
•If you do the Room Setup (see page 28) after making the settings here, those will take precedence.
31
• The default setting is “0 dB”. | En |
