Installation and connection

Fitting a door front panel made by another manufacturer

Preparing the front panel

￿Measure distance X for drilling the hinge holes.

– with spacer bars:

– without spacer bars:

(the front panel must be correspondingly higher)

￿Mark the two hinge holes and the four smaller holes as shown in the diagram.

front panel shown decor side face down, upper edge at the bottom:

if width b increases, measurement a must also be increased

b = 592 mm ￿ a = 21.5 mm

b = 593 mm ￿ a = 22.0 mm

b = 594 mm ￿ a = 22.5 mm

b = 595 mm ￿ a = 23.0 mm

b = 596 mm ￿ a = 23.5 mm

The height of the door front panel H corresponds to the door height of the adjacent units.

￿Drill the two hinge holes (￿ 35 mm/ 15.5 mm deep) in the back of the front panel.

￿Next, drill the four smaller holes (￿ 7 mm/10 mm deep) in the back of the front panel.

74

Page 74
Image 74
Miele WT2789iWPM operating instructions Fitting a door front panel made by another manufacturer, Preparing the front panel