Miele WT2789iWPM operating instructions An unsatisfactory drying result

		Problem solving guide
An unsatisfactory drying result
Problem	Possible cause	Remedy
The laundry is	The load was too small for	In future dry small loads in a
still damp after a	the electronics to assess	timed drying programme.
drying cycle.	the residual moisture
	correctly.
	The laundry has formed a	– Turn the programme selector
	ring in the drum during the	to Stop.
	spin because it was	– Open the door and loosen
	distributed unevenly.	the laundry.
	The laundry has formed a	– Start the drying programme
	ring in the drum during the	again using a lower spin
	thermospin because it was	speed.
	too damp or the spin
	speed was set too high.
	Warm laundry feels damp.	Extend the cool down time, as
		described in the Settings menu.
The laundry is	The required residual	Change the drying levels as
too damp or too	moisture level is between	described in the Settings menu.
dry after a drying	two drying levels.
cycle.
When laundry is	Too vigorous wash action.	Programme in gentle action
dry it feels hard		and more water.
to the touch.	Not enough detergent was	Increase detergent dose to
	used.	prevent limescale build up in
		laundry.
	No fabric conditioner was	Use fabric conditioner in last
	used.	rinse.
There is still	There is a blockage in the	Clean the drain filter and the
water in the drum	water outlet.	drain pump as described in
after drying.		"Problem solving guide –
		Opening the drum door in the
		event of a blocked drain outlet
		and/or power failure".

61