Problem solving guide

Problems with the load size indicator

Problem

Possible cause

 

 

Remedy

The display indicates

Laundry was left in

To recalibrate the sensor to the

a load of <25% or no

the drum when the

zero setting:

load size is indicated

machine was

– Remove the laundry from the

when the drum is full.

switched off. This

 

drum.

 

has decalibrated the

Switch off the machine and

 

sensor from the zero

 

leave the door open.

 

setting.

 

 

Switch on the machine.

 

The load sensor has

 

Turn the programme selector

 

to be recalibrated to

 

 

to Cottons.

 

zero after running

 

 

Press and hold the Load % /

 

the Rinse out fluff

 

 

Detergent % button in until the

 

programme.

 

 

 

following message appears in

 

 

 

 

 

 

the display: Zero setting OK

The display indicates

The load size sensor

Rotate the drum once. If the

a load of 25%, 50%,

has been

display still indicates a load of

75% or 100% when

decalibrated from

25%, 50%, 75% or 100%,

the drum is empty.

the zero setting.

recalibrate the sensor to zero

 

 

again (see above section).

The following will

The drum door is

– Open the drum door.

appear in the display:

closed.

– Recalibrate the sensor to zero

Zero setting not

 

 

again.

possible. Open the

 

 

 

 

door

 

 

 

 

The drying

There is very little or no

 

In future use a timed

programme stops and

laundry in the drum. Drying

drying programme or the

the following

individual garments or items

Warm air timed drying

message appears in

which are already dry can

programme for individual

the display:

also cause the programme

items.

Check load

to be cancelled.

 

 

 

At the end of a drying

The machine has recognised

In future do not exceed

programme the

an overload.

 

 

the maximum load.

following message

 

 

 

 

appears in the

 

 

 

 

display:

 

 

 

 

Check load

 

 

 

 

58

Page 58
Image 58
Miele WT2789iWPM operating instructions Problems with the load size indicator