Installation and connection
Shorten the front panel from the bottom to height H.
Preparing the fixing points
Hold the
Mark the fixing points on the back of the front panel through the holes in the machine door plate (see arrows in the illustration).
Remove the front panel.
Now drill holes ( 2.5 mm/10 mm deep) in the back of the front panel.
Fitting a plinth facing
The gap between the lower edge of the machine plinth and the floor can be closed up using a suitable kitchen furniture plinth facing.
The machine plinth has a special groove in which a plinth facing can be fitted.
Plinth facing dimensions
Length:
Thickness: 8 mm
Height (H): The plinth facing height must be calculated after aligning the height of the machine with the screw feet or after fitting one or two raising kits.
Installation |
Calculate height (H) from the floor up into the groove (on the underside of the
Cut the plinth facing to size.
Slide it into the groove.
Useful tip:
If the machine is fitted on a raising kit, you can use
75
