06Setting up the receiver
The test tone for channel delay is output in the same order as step 5:
R C LS
SW SB RS
After you have completed all the channels in your speaker setup, the volume level returns to normal and COMPLETE, then RESUME shows in the display.
•Using the MCACC system to set up your speaker system will overwrite any previous settings you had for the STANDARD or ADVANCED SURROUND modes.
Setting separate channel levels for listening modes
• Default setting: 0 dB
In addition to the MCACC setup, you can also set relative channel levels from the listening position using the method below. Using CH SELECT (see tip below), it is also possible to set separate channel levels for each of the listening modes.
ADVANCED
STANDARD SURROUND
CH | LEVEL | TEST |
SELECT | TONE |
MASTER
VOLUME
1 Press STANDARD or ADVANCED SURROUND.
2 Press TEST TONE to output the test tone.
The test tone is output in the following order (depending on the speaker setting):
L C R
RS
SW LS SB
• If you don’t hear a test tone from one of your speakers, please refer to Speaker setting on page 45 and Surround back speaker setting on page 46 to make sure you have correctly specified your speaker setup.
52
En
