10Additional information
Problem | Remedy |
Broadcast stations cannot be | • Connect an outdoor antenna (refer to page 20). |
selected automatically. |
|
|
|
No sound from surround or | • Refer to Speaker setting on page 45 to check the speaker settings. |
center speakers. | • Refer to Manually calibrating your listening area (MCACC) on |
| page 51 to check the speaker levels. |
| • Connect the speakers properly (refer to page 21 or page 22). |
|
|
No sound from surround | • Refer to Surround back speaker setting on page 46 to check the sur- |
back speakers. | round back speaker settings. |
| • Refer to Using the Surround Back Channel (SB CH) on page 40 to |
| make sure the SB CH MODE and the sound mode are set for sur- |
| round back sound. |
|
|
No sound from subwoofer. | • Make sure the subwoofer is switched on. |
| • If the subwoofer has a volume knob, make sure it’s turned up. |
| • Switch the Subwoofer setting on page 46 to YES or PLUS. |
| • Switch the LFE attenuator setting on page 47 to 0 dB or 10 dB. |
| • The Dolby Digital or DTS source you are listening to does not have |
| an LFE channel. |
|
|
Noise during playback of a | • Move the cassette deck further from your receiver, until the noise |
cassette deck. | disappears. |
|
|
Sound is produced from | • Set the SIGNAL SELECT to AUTO, DIGITAL or ANALOG accord- |
other components, but not | ing to the type of connections made. (refer to page 37). |
from LD or DVD player. | • Set the digital input settings correctly (refer to page 50). |
| • Make digital connections (refer to page 16) and set the SIGNAL |
| SELECT to DIGITAL (refer to page 37). |
| • Refer to the instruction manual supplied with the DVD player. |
|
|
No sound is output or a noise | • Set the digital volume level of the player to full, or to the neutral |
is output when software with | position. |
DTS is played back. |
|
|
|
When a search is performed | • This is not a malfunction, but be sure to turn the volume down to |
by a DTS compatible CD | prevent the output of loud noise from your speakers. |
player during playback, noise |
|
is output. |
|
|
|
Can’t operate the remote | • Replace the batteries (refer to page 6). |
control. | • Operate within 23 feet ( 7 m), 30° of the remote sensor on the front |
| panel (refer to page 7). |
| • Remove the obstacle or operate from another position. |
| • Avoid exposing the remote sensor on the front panel to direct light. |
The display is dark or off.
•Press FL DIMMER on the remote control repeatedly to return to the default.
66
En
