Controlling the Rest of Your System | 09 |
Recalling Preset Codes
The following steps show you how to recall preset codes for each MULTI CONTROL button. Once the preset code is assigned, pressing the button will automatically set the remote to operate the respective component.
MEMO:
•Refer to “Preset Code List” on pages 43 to 49 for the components and manufacturers available.
•Refer to “Controlling the Rest of Your System” on pages 35 to 49 for detailed explanations on how to operate your other components.
SOURCE | RECEIVER | LED | ||
|
|
|
| |
DVD | TV | VCR | 2 | |
| MULTI CONTROL |
| ||
RCV | CD | TUN | TVC |
|
1 | 2 |
| 3 | 3 |
MIDNIGHT | 5.1 / 7.1 | ATT | ||
4 | 5 |
| 6 | |
|
| EFFECT |
| |
7 | 8 |
| 9 | |
10 |
|
| DISC |
|
| 0 |
| ENTER |
|
DTV INFO MPX/RETURN | D.ACCESS | GUIDE |
| |
¶ | 7 | 3 | 8 |
|
BAND | CLASS | DTV ON/OFF DTV MENU |
| |
1 | ¡ | 4 | ¢ |
|
2/DTS | DSP | TEST TONE | SIGNAL SELECT |
|
CH SELECT | CH LEVEL | FUNCTION |
| |
LOUDNESS | FL DIMMER | SETUP | MUTING | 1 |
TUNE
ST | ST |
| ENTER |
| TUNE |
| CHANNEL |
VOLUME | MASTER VOLUME |
| MENU |
TVFUNC
TV 
TV CONTROL
AV
REMOTE CONTROL UNIT
3Use the number buttons to enter the 4 digit setup code. (see pages
The LED will blink for half a second after each digit is input and will show a long, two second blink to confirm a valid code has been input.
If the LED blinks three times it means an invalid code has been input or an error has occurred. Check the preset code list and try again. If you are not able to input a preset code you can refer to page 38 to teach the remote control individual commands.
The remote control returns to the previous operation mode. It will also return to the previous mode after thirty seconds of inactivity.
4Repeat steps 1 through 3 to assign preset codes for as many components as necessary.
MEMO:
•You can only input a code for the component type written on each MULTI CONTROL button.
•If you recall a preset code for the tuner (TUN MULTI CONTROL), you will not be able to control the built- in tuner of this receiver using the remote. To reset the remote to the
•To erase the preset code for the current MULTI CONTROL button, enter 0000 as the code in step 3.
1Press SETUP and hold for three seconds to select the Preset mode.
The LED lights steadily for two seconds. (VSX- D850S only: The LCD display shows SETUP.)
To cancel the preset mode at any time Press SETUP.
The remote control will also return to the previous mode after thirty seconds of inactivity.
2Press the MULTI CONTROL button for the component you want to control.
Each button can be set to control one of the following components
DVD | DVD/LD player or DVD Recorder |
TV | TV, Satellite tuner or Cable TV tuner |
VCR | VCR or Digital Video Recorder |
CD | CD player |
CD Recorder, Tape deck | |
| or MD player |
TVC | TV or Cable TV tuner |
TUN | FM/ AM tuner |
35
En
