1

2

3

6

+

+

+

Checking what's in the box

Thank you for buying this Pioneer product. Before starting to set up your new stereo system, please check that you have received the following supplied accessories:

Two 'AAA' size R03 batteries

FM wire antenna

Remote control unit

AM loop antenna

Warranty card

Two Speaker Cords

These operating instructions

 

 

Using this manual

This manual is for the X-MT2000. It is split into three sections: setting up (chapters 1 and 2); using the system (chapters 3 to 6), and additional information (chapter 7). This last chapter contains care information for the unit and discs, a troubleshooting section and specifications.

Removing the transport stopper

The transport stopper secures the disc tray for safe transportation. Be sure to remove it before switching the unit on. Keep the stopper in case you need to transport the unit in the future — see Moving the unit on page 29.

1Remove the tape covering the transport stopper on the front of the disc tray.

Tape Stopper

2Pull out the transport stopper.

Putting the batteries in the remote

1Turn over the remote control, then press and slide the battery compartment cover off.

2Put in the batteries supplied.

Take care to match the plus and minus ends of each battery with the markings inside the compartment.

3Slide the cover back on, and your remote is ready for use.

En

Page 6
Image 6
Pioneer X-MT2000 Checking whats in the box, Using this manual, Removing the transport stopper