Additional Information | 11 |
Problem | Remedy |
Noticeable difference in DVD | • DVDs and CDs use different recording methods. This is not a malfunction. |
and CD volume. |
|
|
|
|
|
Tuner |
|
Noisy radio reception | • Check that the frequency is correct. |
| • Check that the antennas are connected properly. For FM, make sure that the antenna |
| is fully extended and positioned to give the best reception. |
| For AM, make sure that the loop antenna is pointing in the best direction. |
| • If the radio signal is weak, an outdoor antenna will usually give better results than the |
| supplied indoor types. |
| • Other electrical equipment, such as TVs, fluorescent lamps and motors can cause |
| interference. Try switching off or moving the equipment, or moving the antenna(s). |
| • The tuning interval may be incorrect for your country or region. Try switching the |
| tuning interval (page 41). |
|
|
Auto tuning does not pick up some stations.
•Auto tuning will only detect radio stations with a good signal. For more sensitive tuning, connect an outdoor antenna.
General |
|
|
The remote control doesn't | • | Make sure that you’re using the remote within its operating range and that there are |
seem to work. | no obstacles between the remote and the sensor on the main unit. | |
| • | Check that the batteries are not exhausted. |
|
|
|
No audio, or audio is dis- torted.
•Check that the correct function is selected (DVD/CD, etc.), the volume turned up.
•Check that the MUTE function is not on and that the disc is not paused.
•Check that the disc is clean and undamaged (page
•Check that all rear panel connections are correct.
•If you find dirty or oxidized plugs/terminals, clean them.
Can’t adjust sound mode | • The Record Mode is switched on. Switch off then adjust as desired (see page 25). |
settings (bass, treble, etc.) |
|
|
|
Static electricity or other external influences may cause malfunctioning of this unit. In this case, unplug the power cord and then plug back in. This will usually reset the unit for proper operation. If this does not correct the problem, please consult your nearest Pioneer service center.
Resetting the system
Resetting the system returns all menu, picture and password settings to their factory defaults.
1Switch the system into standby using the front panel standby/on switch.
2Hold down the front panel 7 button and switch back on.
Switching the demo mode on/off
When you first plug in this system the display shows a demo sequence. The demo will also start if the system is on in the DVD function but idle for more than 5 minutes. The demo will stop if you press any button except CD MODE on the main unit .
•To switch the demo mode off completely, press and hold CD MODE on the main unit for about 3 seconds while the demo is in progress.
•To switch the demo mode on, press and hold CD MODE on the main unit for about 3 seconds while the system is in standby.
45
En
