Input Setup
Input Setup
You can set up your Planar UltraRes display using multiple or single inputs. Both are explained below. You can select multiple or single input mode using the remote control, the UltraRes Control tool or by using RS232 commands. For more information see "Setting Up UltraRes Using Multiple Inputs" on page 32 and "Setting Up UltraRes Using Single Inputs" on page 35.
| Used to receive signals from |
RS232 connector | the remote control. |
Used to connect to the | Used to send serial commands to the |
Remote Monitoring software. | display. Also used for diagnostic purposes. |
Supported Formats for Multiple Inputs
The following formats are supported for multiple inputs:
•(4x) DisplayPort or HDMI/DVI 1080p @ 24/50/60Hz
•PC with DisplayPort or HDMI/DVI (or mix of both)
•External video processors
•(4x) DisplayPort or HDMI/DVI 960 x 2160 @ 60Hz
•Needs a PC with a special graphics card set up
Supported Formats for Single Inputs
The following formats are supported for single inputs:
•(1x) DisplayPort or HDMI 4K @ 24/25/30Hz
•PC with DisplayPort 1.1a or 1.2 output
•4K
Planar UltraRes User Manual | 11 |