Planar CM17.4SXAD, VS17.4SXAD Connecting a Video Device, Connecting the Optional Touch Screen

Installing the Display 9

Connecting a Video Device

Use the following instructions if you are hooking up a camera, VCR, or other S-Video or Composite Video device, and not using the VGA or DVI input simultaneously. These instructions apply to S-Video and Composite Video input-equipped displays only.

1Press the Power/Menu button until the Power ON indicator blinks. After a moment, a No Signal Coming message appears.

2Wait for the No Signal Coming message to disappear, approximately 3 to 5 seconds.

3Press the Power/Menu button to display the VGA → VIDEO menu.

4Press the PLUS or MINUS ( / ) control to enter video mode.

5Press the UP () arrow to change video modes if you are using an alternate video source.

6Press the PLUS or MINUS ( / ) control to select the desired video mode.

Connecting the Optional Touch Screen

If your VitalScreen CSR or VitalScreen CR display has the optional touch screen, connect the display 9-pin D-sub serial port to the computer 9-pin RS-232 serial port using the cable supplied with the touchscreen package. Next, connect the RS-232 cable to the 9-pin serial port on the back panel of the display.

Do not operate the touch screen with sharp objects, such as a scalpel. Sharp objects can scratch or damage the touch screen. A damaged touch screen may pose a safety hazard.

Mounting the Display

When mounting your display, such as to a wall bracket or an articulated swing arm, make sure the maximum length of the screws inserted into the display mounts is 9 millimeters. Forcing the screws deeper into the mounts and exceeding this maximum length may damage the display.

VS17.4SXAD / CM17.4SXAD (020-0168-00B)