The default super user password is “pass”. It is recommended to change the super user password as soon as you get this device.

The Wireless LAN Configuration field is left for future enhancement.

3.3 Configuration via Serial Port

Using a serial terminal, the IKVM-1000 has a serial line interface (host side). This connector is compliant with the RS 232 serial line standard. The serial line has to be configured with the parameters given as below.

Parameter

Value

 

 

Bits/second

115200

 

 

Data bits

8

 

 

Parity

No

 

 

Stop bits

1

 

 

Flow Control

None

 

 

When configuring with a serial terminal, press the reset button of IKVM-1000 and immediately press the “ ESC ” key on the keyboard of administrative PC. You will see some device information, and a “ => ” prompt. There are four commands available.

config: start configuration tool after boot up

defaults: set the device settings to factory defaults

help: print online help

reset: perform a soft reset

When using “config” command, the following interactive options will appear:

IP auto configuration (non/dhcp/bootp) [dhcp]:

With this option, you can specify whether the IKVM-1000 should get its network settings from a DHCP or BOOTP server. For DHCP, enter “dhcp”, and for BOOTP enter “bootp”. If you do not specify any of these, the IP auto configuration is disabled and subsequently you will be asked for the following network settings.

IP [192.168.1.1]:

This is the current IP address of the IKVM-1000. This option is only available if IP auto configuration is disabled.

Net mask [255.255.255.0]:

8