User’s Manual of ICS-10x
To press and release the RESET button. The ICS-10X will back to the factory default mode. Be sure that you backup the current configuration of ICS-10X; else the entire configuration will be erased when pressing the “RESET” button.
•Press and release the RESET button shortly, the device will be rebooted.
•Press the RESET button more than 10 seconds, the device will back to the factory default mode; the entire configuration will be erased.
2.2Install the Converter
This section describes how to install your ICS-10X Web Smart Media Converter and make connections to the converter. Please read the following topics and perform the procedures in the order being presented. The hardware installation of PLANET ICS-10X Web Smart Media Converter do not need software configuration. To install your ICS-10X on a desktop or shelf, simply complete the following steps.
2.2.1 Stand-alone Installation
To install an ICS-10X stand-alone, on a desktop or shelf, simply complete the following steps:
Step 1: Turn off the power of the device/station in a network to which the ICS-10X will be attached.
Step 2: Ensure that there is no activity in the network.
Step 3: Attach RJ-45 / SC Fiber cable from the ICS-10X to the network.
Step 4: Attach RS-232/RS-485 cable from the ICS-10X to the want to connect devices.
Step 5: Connect the 5VDC power adapter to the ICS-10X and verify that the Power LED lights up.
Step 6: Turn on the power of the device/station; the PWR LED (Green) should light when all cables are attached.
Figure 2-6ICS-100 stand alone installation