Broadband VPN Router User’s Manual
Figure53: VPN Wizard - Traffic Selector Screen∙For outgoing VPN connections, these settings determine which traffic will cause a VPN tunnel to be created, and which traffic will be sent through the tunnel.
∙For incoming VPN connections, these settings determine which systems on your local LAN will be available to the remote endpoint.
∙The 2 VPN endpoints MUST use different address ranges.
If the addresses were in the same range, traffic intended for the remote VPN would be con- sidered local LAN traffic. So it would not be forwarded to the Gateway.
Local IP addressesType | ∙ Any - no additional data is required. Any IP address is accept- |
| able. |
| ∙ For outgoing connections, this allows any PC on the LAN to |
| use the VPN tunnel. |
| ∙ For incoming connections, this allows any PC using the re- |
| mote endpoint to access any PC on your LAN. |
| ∙ Single address - enter an IP address in the "Start IP address" |
| field. |
| ∙ Range address - enter the starting IP address in the "Start IP |
| address" field, and the finish IP address in the "Finish IP ad- |
| dress" field. |
| ∙ Subnet address - enter the desired IP address in the "Start IP |
| address" field, and the network mask in the "Subnet Mask" field. |
| The remote VPN must have these IP addresses entered as it's "Re- |
| mote" addresses. |
|
|
80