Preparing the Remote Control
Button Battery Replacement
Using the remote control for the first time
The battery compartment is fitted with a transportation insulation sheet at the time of shipping. Pull out the sheet and remove it. The remote control is now ready for use.
Replacement Method
1 (A) With the knob pressed to the right side, (B) draw out the battery case.
2 Remove the old battery and in- stall a new button battery with (+) side facing upward in the battery holder.
3 Insert the battery holder into the re- mote control and push in until the battery holder closes with a “click” sound.
(B)
(A)
CR2025 | CR2025 |
|
Purchase a CR2025 type battery for replacement.
CR2025
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type (CR2025) recommended by the manufacturer. Dispose of used batteries according to your local regulations.
CAUTION
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
Remote Control Range
Point the infrared transmitter of the remote control toward the remote control sensor located at the front or rear of the main unit and operate.
Reception of the remote control signal should generally be possible within the range illustrated below.
4m/13. |
|
1 | feet |
|
30°
Remote control
sensor ° 30
20° 
7m/23.0 feet | Side View |
|
20° | Remote con- |
| |
| trol infrared |
| transmitter |
6m/19.7 feet
3m/9
. 8
feet
50°
.1 | feet |
| |
4m/13 |
|
50° | Remote control in- |
frared transmitter | |
7m/23.0 feet | Remote control |
sensor | |
| Top View |
Note
*Exposure of the main unit’s remote control sensor or the remote control infrared transmitter to bright light or the obstruction of the signal by an obstacle located in the pathway may prevent operation.
*To prevent operational difficulties with the sensor when the projector is installed suspended, install the projector 1.5 m or further from fluorescent lighting.
*The remote control will not function when the battery is exhausted.
