Setup
Eco Mode
Use this if the picture is projected on a small screen and the picture is too bright or when projecting images in dark rooms.
Select the item name “Eco Mode” and select the setting contents with the SELECT ( ) buttons.
On | The lamp’s brightness is reduced to approximately 80%, extending the |
| lamp’s service life. |
| (STATUS indicator is green) |
Off | The lamp brightness is set to 100% and the screen is bright. |
| (STATUS indicator is off) |
Note:
Frequent switching this mode can degrade the lamp.
POWER
STANDBY STATUS
STATUS indicator
Input Format
This function is used in setting the input signals of the input connec- tors.
Normally, this should be set to Auto. When identification is not possible with Auto, make the setting.
Select the item name “Input Format”, press the ENTER button, and the sub menu will open.
Select the connector that is to be changed, and select the setting contents with the SELECT ( ) buttons.
[Computer]
This is the signal setting for the COMPUTER IN con- nector.
Auto ............ Automatically identifies the signal.
Computer ... Analog RGB signal is set.
Component . Component signal is set.
[Video] and [S-Video]
[Video] is the color system setting for the VIDEO connector and
Auto | Automatic identification. |
NTSC | Fixed to the NTSC system. |
PAL | Fixed to the PAL system. |
SECAM | Fixed to the SECAM system. |
NTSC 4.43 .. | Fixed to the NTSC 4.43 system. |
PAL M | Fixed to the PAL M system. |
PAL N | Fixed to the PAL N system. |
PAL 60 | Fixed to the PAL 60 system. |
|
|
