User’s Guide for the Polycom Mobile Responder
Power
Symptom | Problem | Corrective Action |
|
|
|
The system does not | The Power button is off. | 1. Press the Power button located inside the side panel |
start or respond in |
| to the on position. |
any way. |
| 2. Wait one to two minutes for the system to |
|
| completely power on. |
|
|
|
| The power cable is not | Make sure the power cable is connected to a power |
| connected. | outlet, and that the power cable is seated securely both |
|
| in the outlet and in the Mobile Responder. |
|
|
|
| The power outlet is not active, | Check the power outlet by unplugging the system and |
| or the system’s power cable | plugging in a lamp, radio, or other small appliance. If it |
| is not operating properly. | does not operate, the outlet is not active — connect the |
|
| system to a different outlet. |
|
| If the outlet is active, the problem may be in the Mobile |
|
| Responder’s power cable. In this case, call Polycom |
|
| Technical Support. |
|
|
|
| The power interlock switch is | Make sure that the power interlock switch, which turns off |
| pushed down. | power to the lid, is up (refer to Identifying System Parts |
|
| on page |
|
| interlock switch is located). |
|
|
|
The screen is blank. | The system is in standby | Pick up the remote control to activate the system. |
| mode. |
|
|
|
|
| The power for the display is | Press the LCD Power button to turn the display on (refer |
| off. | to Identifying System Parts on page |
|
| showing where the LCD Power button is located). |
|
|
|
| The wrong display mode is | Press the LCD Up/Display Mode button until you set the |
| selected. | display mode to RGB (refer to Identifying System Parts |
|
| on page |
|
| Up/Display Mode button is located). |
|
|
|
3 - 2
