Polycom EX4000, FX4000, VS4000, EX, FX, VS4000 manual To install the PRI network interface module

Integrators’ Reference Manual for ViewStation EX, ViewStation FX, and VS4000

Installation

To install the PRI network interface module:

1.Ensure that the system is powered off.

2.Connect peripheral side of the PRI network interface module to the system using the supplied cable. Figure 4-5shows the peripheral side of the PRI network interface module.

Port		Input Port
(not	used)

LEDs

Figure 4-5.PRI Network Interface Module (Peripheral Side)

3.Connect the 12-volt DC power supply to the PRI network interface module and then to the UPS or wall outlet.

4.Connect the PRI network interface module to the ISDN network.

Network

Connector

LEDs

Figure 4-6.PRI Network Interface Module (Network Side)

You are now ready to power on and configure the system.

84 www.polycom.com