Polycom EX4000, FX4000, VS4000 manual To install V.35/RS-449/RS-530 Network Interface Module

Integrators’ Reference Manual for ViewStation EX, ViewStation FX, and VS4000

Installation

To install V.35/RS-449/RS-530 Network Interface Module:

1.Make sure the system is turned off.

2.Connect the peripheral side of the network interface module to the system. Refer to Figure 4-7.

12 VDC Connector	Port (not used)
(not used)		Input Port

LEDs

Figure 4-7.V.35/RS-449/RS-530 Network Interface Module (Peripheral

Side)

3.Connect the network side of the network interface module to the DCE, shown in Figure 4-8below. If you have only one cable, connect it to port 1.

LEDs

Figure 4-8.V.35/RS-449/RS-530 Network Interface Module (Network Side)

86 www.polycom.com