ASSEMBLY
FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.
1.Assemble the column (A) Fig. 3, to the base (B) using the four M10x40mm hex head screws (C), three of which are shown. Loosen set screw (D) with 3mm wrench supplied, and remove ring (E) and raising rack (F).
2.Insert small end of worm gear (G) Fig. 4 and Fig. 5, through hole (H), from the inside of the table bracket. Make certain that the worm gear engages the internal gear in the table bracket.
G
H
Fig. 4
3.Insert raising rack (F) Fig. 6, which was removed in STEP 1, into groove in table bracket (I) making sure teeth of internal gear, located inside table bracket, are engaged with teeth of raising rack (F).
ED
F
A
B
C
Fig. 3
H
G
Fig. 5
I F
Fig. 6
7
