FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.
BLADE TILTING LOCK KNOB
Thread lock knob (A) Fig. 4, into threaded end of the shaft
(B).
B
A
Fig. 4
ATTACHING HANDWHEELS
1.Tighten lock knob (A) Fig. 5 on the blade height adjusting wheel.
2.Thread handle (C) Fig. 5, into the tapped hole (D), and tighten securely.
3.Repeat this process for attaching the handle for the blade tilting operating wheel (E) Fig. 5.
EXTENSION WINGS
Assemble the extension wing (A) Fig. 6 , to the left side of the saw table using the three M10x1.5x35mm hex head screws (B) and M10.1 lockwashers supplied. NOTE:
MAKE SURE FRONT EDGE OF WING IS FLUSH TO OR SLIGHTLY BEHIND THE FRONT EDGE OF THE TABLE. Use a straight edge (C) Fig. 7, to make sure the extension wing (A) is level with the saw table before tightening the screws (B) Fig. 6 with a 17mm wrench.
Assemble the right extension wing in the same manner.
E
A
D
C
Fig. 5
A |
B |
Fig. 6
C
Fig. 7
9
