BLADE GUARD AND SPLITTER ASSEMBLY
1.Remove the table insert (A) Fig. 8, by removing screw
(B) and pulling out on the table insert. Remove the blade by following the instructions in section “CHANGING THE SAW BLADE”.
2.The inside splitter mounting bracket (A) Fig. 9, is assembled to the inside of the saw and aligned with the inside blade flange (B) at the factory.
3.To check the alignment, remove screw and fastener plate (C) Fig. 9. Using a straight edge (D) Fig. 10, check to see if the splitter bracket (A) is aligned with the inside blade flange (B). Check both the top and bottom of bracket (A) with the top and bottom of flange (B).
4.If an adjustment is necessary, loosen screws (F) and
(G) Fig. 11, and adjust splitter bracket (A) until it is aligned with the inside blade flange (B) Fig. 9. Tighten screws (F) and (G) Fig. 11. Loosely assemble screw and fastener plate (C), which were removed in STEP 3, Fig. 9.
B
A
Fig. 8
A
C
B
Fig. 9
A
B
D
Fig. 10
A
F
G
Fig. 11
10
