Pushstick, Constructing a Push Stick | Porter-Cable 36-729 guide

CONSTRUCTING A PUSH STICK

When ripping work less than 4 inches wide, a push stick should be used to complete the feed and could easily be made from scrap material by following the pattern shown.

PUSHSTICK	MAKEFROM1/2"OR3/4" WOODORTHICKNESS LESSTHANWIDTHOF MAT’L.TOBECUT		NOTCHTOHELP PREVENTHAND FROMSLIPPING
	CUTOFFHERETO PUSH1/4"WOOD	CUTOFFHERETO PUSH1/2"WOOD	1/2"SQUARES

24

Image 24

Porter-Cable 36-729 instruction manual Pushstick, Constructing a Push Stick

Contents

Cabinet Saw Table of Contents Important Safety Instructions Safety Guidelines Definitions California Proposition General Safety Rules Stay ALERT, Watch What YOU are DoingUSE of this Tool can Generate and Disburse Dust or Other Additional Specific Safety Rules Failure to Follow These Rules MAY Result in Serious Injury Power Connections Motor SpecificationsGrounding Instructions Carton Contents Functional Description Assembly Assembly Tools Required Blade Tilting Lock Knob Attaching HandwheelsExtension Wings Blade Guard and Splitter Assembly Insert threaded end of support rod / splitter bracket Page Motor Cover Table Insert a should Always be Level with the Table Locking Switch OFF Position OperationStarting and Stoping the SAW Blade Raising Handwheel Replacing Belts Adjusting Belt Tension Disconnect Machine from Power SourceChanging the SAW Blade Adjusting 90 and 45 Degree Positive Stops Adjusting Table Adjusting Table Insert Miter Gage Operation and Adjustment Never USE the Fence AS a CUT-OFF Gage When CROSS-CUTTING Common Sawing OperationsCROSS-CUTTING Ripping Constructing a Push StickGuard Removed for CLARITY. Always USE the Guard Using Moulding Cutterhead Accessory Dado Head Troubleshooting Using Auxiliary Wood Facing on RIP FenceConstructing a Featherboard Pushstick Constructing a Push Stick Maintenance ServiceAccessories WarrantyPage Page Canadian PORTER-CABLE Delta Service Centers