Porter-Cable C6110 Replace or Clean Check Valve, Do not drill into, weld or otherwise

Models: C6110

1 72
Download 72 pages 63.66 Kb
Page 18
Image 18

PROBLEM

CAUSE

 

 

CORRECTION

Air leaks at

Check valve seat

A defective check valve results in

or inside

damaged.

a constant air leak at the pressure

check valve

 

release valve when there is pressure in

 

 

the tank and the compressor is shut

 

 

off. Replace check valve. Refer the To

 

 

Replace or Clean Check Valve in

 

 

the Service and Adjustments section.

Air leaks at

Defective pressure

Contact a Trained Service Technician.

pressure switch

switch release valve.

 

 

 

 

release valve

 

 

 

 

 

Air leaks in air

Defective air tank.

Air tank must be replaced.

tank or at air

 

Do not repair the leak.

tank welds

 

 

 

 

Risk of bursting.

 

 

 

 

 

 

 

 

 

 

 

Do not drill into, weld or otherwise

 

 

modify air tank or it will weaken. The

 

 

tank can rupture or explode.

Air leaks

Leaking seal.

Contact a Trained Service Technician.

between head

 

 

 

 

 

and valve plate

 

 

 

 

 

Pressure

It is normal for "some"

If there is an excessive amount of

reading on

pressure drop to occur.

pressure drop when the accessory

the regulated

 

is used, adjust the regulator as

pressure gauge

 

instructed in the Operation section.

drops when

 

NOTE: Adjust the regulated

an accessory

 

pressure under flow conditions

is used

 

(while accessory is being used).

Air leak from

Possible defect in

Operate safety valve manually

safety valve

safety valve.

by pulling on ring. If valve still

 

 

leaks, it should be replaced.

Compressor is

Prolonged excessive

Decrease amount of air usage.

not supplying

use of air.

 

 

 

 

enough air

Compressor is not

Check the accessory air requirement. If

to operate

large enough for

it is higher than the SCFM or pressure

accessories

air requirement.

supplied by your air compressor,

 

 

you need a larger compressor.

 

Hole in hose.

Check and replace if required.

 

 

 

 

 

 

 

Check valve restricted.

Remove and clean, or replace.

 

Air leaks.

Tighten fittings.

 

Restricted air intake filter.

Clean or replace air intake filter. Do not

 

 

operate the air compressor with the

 

 

filter removed. Refer to the Air Filter

 

 

paragraph in the Maintenance section.

Restricted

Dirty air filter.

Clean or replace. See Air Filter

air intake

 

paragraph in the Maintenance section.

Regulator knob

Damaged regulator.

Replace.

has continu-

 

 

 

 

 

ous air leak.

 

 

 

 

 

Regulator will

Damaged regulator.

Replace.

not shut off

 

 

 

 

 

air outlet.

 

 

 

 

 

18- ENG­

Page 18
Image 18
Porter-Cable C6110 Replace or Clean Check Valve, Do not drill into, weld or otherwise, Tank can rupture or explode