240 VOLT SINGLE PHASE OPERATION

!WARNING

To avoid injury, disconnect the motor from power source outlet before reconnecting the wire.

The motor supplied with your machine is a dual voltage, 120/240 volt motor. It is shipped ready-to-run for 120 volt operation. However, it can be converted for 240 volt operation, reconnect the motor wire as the wiring diagram on page 28.

A qualified electrician should do the conversion, or the machine can be taken to an Authorized Service Center. When completed, the machine must conform to the National Electric Code and all local codes and ordinances.

The machine is converted by re-wiring the motor for 240 volts, installing a 240 volt plug on the power supply cord and replacing the switch with one that is rated for 240 volt operation.

Be sure the 240 volt plug is only used in an outlet having the same configuration as the plug illustrated in Fig. 1. No adapter should be used with the 240 volt plug.

!CAUTION

In all cases, make certain that the receptacle in question is properly grounded. If you are not sure, have a qualified electrician check the receptacle.

TOOLS NEEDED FOR ASSEMBLY

Supplied

Not Supplied

Blade wrench

Medium screwdriver

6 mm hex key

Phillips screwdriver

 

Straight edge

Adjustable wrench

10, 13, 17 mm hex wrench

Combination square

– 8 –

Page 8
Image 8
Porter-Cable PCB270TS instruction manual Volt Single Phase Operation, Supplied Not Supplied