Assembly and Adjustments

Estimated Assembly Time: 90~120 minutes (2 people)

!WARNING

For your safety, never connect plug to power source receptacle until all assembly and adjustment steps are complete, and you have read and understood the safety instructions.

ASSEMBLING STAND (FIG. A~I)

1.Unpack all parts and group by type and size. Refer to parts list for quantities. The number is labeled on each leg and leg support, please identify before assembling.

2.Bag “C” - Attach the right leg support (1) to the front right leg (2) and rear right leg (3) with six square neck bolts (10) and six nuts (11) to complete right frame leg.

NOTE:

•Do not tighten bolts until stand is properly aligned.

•Position all supports to the INSIDE of the leg assembles.

•Align detents (12) in stand leg with supports to ensure proper ﬁt.

3.Repeat above steps for the left frame leg - left leg support (4), front left leg (5) and rear left leg (6).

	Fig. A	12
	Fig. A	1
		1
	11
	Front	3

210

5.Bag “C” - Join the right frame leg and the left frame leg by using the rear top / bottom leg support (8, 9), six square neck bolts (10) and six nuts (11).

Fig. C	11	10
Fig. C		8

Front

6.Bag “F” - Place three foot pads (13) onto the legs (3, 5, 6), thread the adjustable foot pad with hex nut (14) into the front right leg (2).

7.Place stand on level surface and adjust, so all legs are contacting the ﬂoor and are at similar angles to the ﬂoor and detents in stand leg align with supports, then tighten all bolts.

NOTE: Stand should not rock after all bolts are tightened.

Fig. D		6
Fig. D
	5		3
			3
		13	2
		13
		Front
		14

4.Bag “C” - Join the right frame leg and the left frame leg by using the front leg support (7), four square neck bolts (10) and four nuts (11).

Fig. B	4	6
		6

5		11
5

8.Bag “H” - Install the front casters (15) and rear casters (16) to the bottom of the caster bracket (17). NOTE: Identify the front casters and rear casters before installing.