Porter-Cable PCB270TS Assembling Table SAW to Stand FIG. J, Moving Table SAW and Stand FIG. J

9.Bag “I” - Mount the pedal (1) to the caster bracket

(2)by using the longest bolt (3) and nut (4), and attach the link (5) to pedal (1) with bolt (6) and nut

(4)by 6 mm hex key supplied.

Fig. F

5

4	6	Right side
1		view

4

3

2

10.Bag “I” - Attach the left / right rear tubes (8) of caster bracket into the brackets (9) of the rear legs by using two short bolts (10). Attach the link (5) into the bracket (11) with bolt (6) and nut (4).

NOTE: Do not over tighten bolts. The caster assembly will be difficult to operate if the bolts are too tight.

Fig. G

			9
11
4	5	8	10
	6

NOTE: The front right / left legs have been removed from this drawing for illustration purposes only.

11.Bag “J, K” - Attach miter gauge storage (12) to the right leg support by using two short screws (14) and nuts (15).

13.Insert the rip fence storage (20) into slots (21) of the left leg support, tighten by using two of six screws (22).

Fig. I	18	16
	22	15
	20
		21

NOTE: Make sure all screws and nuts are tight and stand is on a stable surface before mounting saw.

!WARNING

Although compact, this saw is heavy and should be lifted with care. Get the assistance of someone to lift and move the saw.

!WARNING

For your safety, never connect plug to power source receptacle until all assembly and adjustment steps are complete, and you have read and understood the safety instructions.

ASSEMBLING TABLE SAW TO STAND (FIG. J)

1.Lift the saw body (1) and place on the stand (2), aligning the mounting grooves (3) of the saw base with the four mounting holes on the top plate of stand.

2.Bag “P” - Attach the table saw to the stand with four hex head bolts (4).

3.Tighten all mounting bolts with a wrench.

Fig. J

Fig. H	12
15	14

4 1

3 2

12.Bag “J, K” - Attach power cord storage (16) to the left leg support by using two long screws (18) and nuts (15).

5 6

MOVING TABLE SAW AND STAND (FIG. J)

1.Tread on the area (5) of pedal to lift the saw and stand when stand legs contacting the level surface.

2.Move the saw and stand to the desired location by the caster assembly for operation or storage.

3.Tread on the area (6) of pedal to put the saw and stand on the ground.

–14 –