Porter-Cable PCB270TS instruction manual Storage FIG. L ~ R, Anti-kickback pawl storage Fig. L

INSTALLING THE ANTI-KICKBACK PAWL AND BLADE GUARD ASSEMBLY STORAGE (FIG. K) Storage brackets for anti-kickback pawl and blade guard

assembly are located on the right side of the saw base.

1.Bag “J, K” - Insert the bracket (1) into the left slot (2) on the right side of saw base, attach the brackets by using two of six screws (22).

2.Bag “J, K” - Insert the support plate (4) into the right slot (5), attach the support plate by using two od six screws (22).

Fig. K

1

	22
2	5
	4

22

STORAGE (FIG. L ~ R)

Anti-kickback pawl storage (Fig. L)

Storage brackets for anti-kickback pawl (1) is located on the right side of the saw base.

1.Take the anti-kickback pawl assembly (1) and lift up the locking lever (2) located on top.

2.Place the front of assembly into slot (3) and push down making sure the assembly is engaged in the slot (3, 4). There should be no movement of the assembly. Push down on the locking lever.

Fig. M

1

2

3
4	5

Blade wrench & push stick storage (Fig. N, O) Storage for blade wrench and push stick is located on the right side of the saw base.

1.Hang the blade wrench (1) on the holder (2) as shown.

Fig. N

2 1

2.Insert the holders (2) through the holes (3) of the push stick (4).

Fig. O

Fig. L	1
	4
	3
	2

Blade guard assembly storage (Fig. M)

Storage brackets for blade guard assembly (1) is located on the right side of the saw base.

2

Riving knife storage (Fig. P)

3

4

1.Take the blade guard assembly (1) and locate the sliding locking knob (2) on the back of assembly.

2.Slide the locking knob up and press the guard assembly down along the step (3) so that the ball engages into hole (4) completely.

3.Release the locking knob. Make sure that the assembly is locked in place and supported by plate (5).

Storage for riving knife (1) is located on the right side of the saw base. Insert the riving knife through the holder

(2) as shown.

– 15 –