Installation

 

 

X-Slot

 

Input Circuit

 

 

 

 

Network Transient

 

 

 

 

Four 10A, IEC-320

Communication Bay

 

Protector

 

 

 

 

 

 

Protector

 

 

 

 

Receptacles

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

10A, IEC-320 Input Connector

 

USB Port

 

 

 

DIP Switches

 

 

 

 

 

 

 

Communication Port

Figure 12. 500–1500 VA, 230V Rear Panel

5.Plug the UPS power cord into a power outlet.

The UPS is in Standby mode with the equipment offline. All indicators are off.

6.Press and hold the button until you hear the UPS beep (approximately two seconds).

The front panel indicators cycle through a startup sequence

while the UPS conducts a self-test. When the self-test is complete, the UPS enters Normal mode. The •, Load 1, and Load 2 indicators illuminate indicating that power is available from the UPS output receptacles.

If the alarm beeps or a UPS alarm indicator stays on, see Table 8 on page 48.

NOTE The batteries charge to 90% capacity in approximately 3 hours. However, it is recommended that the batteries charge for 6 to 24 hours after installation or long-term storage.

28

Powerware® 5115 Rack-Mount User’s Guide : 164201449 Rev A www.powerware.com