C H A P T E R 5
ADDITIONAL UPS FEATURES
This section describes:
:Changing the voltage configuration
:The Network Transient Protector
:Load segments
Voltage Configuration
The DIP switches on the UPS rear panel (see Figure 14) are used to configure the output voltage and input voltage range.
1.The UPS must be completely shutdown.
To turn off the UPS, press and hold the 
button for two seconds and then unplug the UPS from the power outlet.
2.Set the DIP switches according to the configurations in Table 1.
3.Plug the UPS into a power outlet.
4.Press and hold the 
button until you hear the UPS beep (approximately two seconds) to turn the UPS on.
UPS Rear Panel
ON
OFF
1 2
Figure 14. DIP Switches
Powerware® 5115 | 31 |