Installation

Communication Port

EBM Battery Connector

EBM Cable

UPS Battery

Connector

Power Cord

Output Receptacles

Figure 2. Typical Installation with Two EBMs

4.If you are installing power management software, connect your computer to the UPS communication port using the supplied communication cable.

5.On 208V/230V models, plug the detachable UPS power cord into the input connector on the UPS rear panel.

6.Plug the UPS power cord into a power outlet. The front panel indicators cycle through a startup sequence while the UPS conducts a self-test.

When the self-test is complete, the µindicator flashes, indicating the UPS is in Standby mode with the equipment offline. If the alarm beeps or a UPS alarm indicator stays on, see Table 9 on page 44.

7.Plug the equipment to be protected into the appropriate UPS output receptacles (see page 32 for more information on load segments).

DO NOT protect laser printers with the UPS because of the exceptionally high power requirements of the heating elements.

18

Powerware® 5125 Tower (1000–2200 VA) User’s Guide S Rev B www.powerware.com