32 | Assembling and Maintaining Elliptical Fitness Crosstrainers: EFX 883 / 833 | ||
| Cable | Connector Type | Circuit |
|
|
| Connector |
|
|
| Location |
| Heart rate sensors |
| |
| Safety key |
| |
| (treadmills only) |
|
|
| CSAFE |
| |
|
| flat gray cable |
|
| Auto Stop sensor |
| |
| (treadmills only) |
|
|
To simplify installation and maintenance, route and connect cables 1 through 5 according to the following instructions.
Note: In the illustrations in this section, some cables are omitted for the sake of clarity.
Connecting the Television Cable
The console’s television tuner is mounted inside the console’s back plate. The tuner includes a short cable adapter that allows the television cable to be connected outside the back plate.
To connect the television cable:
1.Pull the cable out through the lower right corner of the back plate.
2.Route the cable counterclockwise around the outside of the back plate.
3.Attach the connector on the cable to the connector on the tuner cable and tighten the two connectors securely using two
4.Use a plastic tie to secure the connectors to the top of the back plate. Pass the tie through the two small holes near the upper right corner of the back plate, then wrap it around the connectors and tighten it securely. Cut off and remove the protruding end of the tie.