CAUTION: Do not remove the
Note: After extensive use, vibrations from the treadmill may cause the clamp to loosen. You may need to periodically inspect the screws and, if necessary, tighten the handrail clamp screws using the hex key (G) provided.
e.Proceed to the other side of the treadmill and follow steps a through d to complete the installation of the lower handrails.
24.Return to the upper handrail clamp, look underneath the clamp to be sure that the handrail ends meet in the middle of the clamp, readjust the handrails if necessary, and tighten the screws securely using the hex key (F) provided.
25.If you need to move the treadmill, ask for additional assistance. Check to be sure the treadmill is turned OFF and the power cord is unplugged from the power outlet. Roll the treadmill on its front wheels to the new location by lifting the rear end of the unit.
26.Plug the treadmill into a standard 120v household outlet. Make sure that no other appliances use the same circuit as the treadmill.
27.Continue on to Checking the Alignment of the Running Belt on the following page to complete the installation of the treadmill.
CAUTION: Do not walk on the running belt during this procedure.
CAUTION: If you hear or notice any chafing or the running belt appears to be getting damaged, stop the running belt immediately by pressing the STOP key. Contact a Precor Service Representative.
Checking the Alignment of the Running Belt
The belt is aligned at the factory before shipment. However, during shipment or by using the treadmill on an uneven surface, the belt might move off center. Proper belt alignment is important because it allows the belt to remain centered and assures smooth operation. Follow these steps to check the alignment:
1.On the electronic console, move the magnetic safety key to the ACTIVATE position. Locate the ON/OFF switch at the front of the treadmill and turn ON the treadmill.
2.Stand beside the treadmill and answer the standard
a.At the “ENTER WEIGHT” prompt, specify a weight and press the SCAN/ENTER key.
b.At the “SELECT COURSE” prompt, use the arrow keys to select “MANL” (Manual) mode and press SCAN/ENTER.
3.Continue standing next to the treadmill and bring the running belt up to a speed of 2 miles per hour by pressing the SPEED 
key.
4.Walk to the back of the treadmill and observe the belt as it moves (watch for a couple of minutes).
| If the running belt,… | Then,... |
|
|
|
| tracks within the green portion | the belt is functioning correctly |
| of the label | and no adjustment is necessary. |
|
|
|
| runs or drifts into the red portion | you need to adjust the belt; |
| of the label | see Aligning the Running Belt in |
|
| Chapter 6. |
Important: If you notice that the belt needs alignment, make the adjustments at once. Failure to do so might cause the belt to tear or fray which is not covered by the Precor limited warranty.
5.Press STOP or SPEED 
until the running belt stops.
If the belt is functioning correctly, the treadmill is ready to use.
page 9
