Once you reach your desired rest speed, the treadmill remembers that speed and returns to it at the beginning of each rest interval, until you change the speed or end your workout.
2.The next scrolling prompt requests that you specify your work speed (and work incline —
M9.2s only). With one hand on the handrail, use the other hand to press the SPEED 
keys until the desired work speed (up to 9 mph) is shown. When you are comfortable with the rest and work speeds, you can let go of the handrail.
Note: On the M9.1, use the incline crank handle to change the degree of incline. Hold onto the handrail with one hand while you rotate the crank in a clockwise direction to raise the incline with the other hand. To lower the incline, rotate the handle counterclockwise.
Each rest and work interval lasts 60 seconds. The display automatically counts down to the next interval. When the count reaches 30 seconds, the display changes and gives information about distance travelled, time elapsed, speed, calories burned, and percent of incline.
When the treadmill changes intervals, it informs you by scrolling a message across the display.
Using the interval course mode, you can cool down before ending your workout by pressing STOP twice in quick succession. The treadmill enters manual mode, letting you specify the speed of your
CAUTION: If this is the first time you have operated this treadmill, DO NOT STAND on the running belt until you become familiar the M9.2s operation. Be sure to read and follow the general guidelines found in “Working Out on Your Precor Treadmill.”
CAUTION: Before beginning any fitness program, you should have a complete physical examination by your physician. If you are unsure about your level of fitness, consult your physician. Always start your workout at the low or “WALK 1” level and work to increase your level of fitness before perform- ing moderate or advanced workout routines.
Using the M9.2s Preprogrammed Courses
To use a preprogrammed course, follow the instructions below. Remember, when you use the electronic console, hold onto the handrail to maintain your balance. You should also use the handrail whenever you speed up, slow down, or stop the treadmill.
1.On the electronic console, move the magnetic safety key to the ACTIVATE position as shown in Diagram 11, page 10. Walk to the front of the treadmill and turn ON the treadmill using the ON/OFF switch. The treadmill switch will not turn ON unless the safety key is seated securely in the ACTIVATE position.
2.Straddle the running belt with your feet firmly planted on the right and left side platforms. Stand close enough to the electronic console so that you can extend your arms and activate the keys.
3.Using the clip provided, securely attach the magnetic safety key to your clothing at your waistline, where it will not interfere with your workout.
4.When you see “ENTER WEIGHT” scroll across the display, specify your weight using any 
key. When the correct weight is displayed, press ENTER. This information allows the M9.2s to calculate how many calories you use during your workout.
The number on the display moves in 
to increase and 
to decrease the weight displayed.
Once your weight is specified, you may not need to enter it again. The treadmill automatically remembers the last weight entered (unless the treadmill is turned OFF). At your next workout, you restore your weight from the treadmill’s memory by simply pressing ENTER at the “ENTER WEIGHT” prompt. However, if someone else has used the treadmill and made changes prior to your workout, you will need to
Note: The prompt “PRESS ENTER TO BEGIN” appears after a few seconds if you have not chosen a course and pressed ENTER. This prompt continues to scroll across the display every few seconds until you press ENTER.
page 18
