Premier Mounts SCM-103 installation instructions Lifting the Display into Position

SCM-103

Lifting the Display into Position

IN THE NEXT STEP A LIFTING DEVICE SUCH AS A FORKLIFT , SCISSOR LIFT, OR HOIST WILL NEED TO BE UTILIZED IN ORDER TO LIFT DISPLAY INTO POSITION. NOT DOING SO COULD RESULT IN PERSON- AL INJURY OR DAMAGE TO THE DISPLAY.

THE SCM-103 IS HEAVY. IT IS STRONGLY RECOMMENDED THAT THREE PEOPLE PERFORM ALL INSTALLATION STEPS.

The display may be hung from a ceiling structure using two (2) main support cables and two (2) safety cables. Length, mounting location and method of attachment will be provided by the installer. The components (below) that are used to hang the SCM-103 are sold separately and may be ordered through Premier Mounts (800) 368-9700.

1/4” stainless steel 7 x 19 wire rope assembly w/ 1/2” - 20 NF stainless steel threaded stud with 3-1/2” thread min. on one end only

1/2-20 NF hex nut	Flat Washer	1/4” Steel Thimble
(Qty 18)	(Qty 8)

1/4” Cable

1/4” Redundancy Cable

Support Bar

1/2-20 Hex Nut and Flat Washer 1/2-20 Threaded Stud

Bracket Cover

1/2-20 Hex Nut and Flat Washer 1/2-20 Threaded Stud

Cable Access Channel

Pre-Hung

Cable

Fork Lift

Display Sucured to

Pallet

Scissor Lift

Step 1. Raise the display to the desired height (Refer to the display manufacturer specs on raising the display into position and the different options available).

Page 8 Installation Instructions