TOC | INDEX |
Section 6: Maintenance and
Troubleshooting
The Publisher is designed to operate for extended periods of time with very little attention. In fact, no regular maintenance is recommended other than cleaning the outside case.
NOTE: Do NOT attempt to oil or grease the Publisher's Robotic Arm shaft or other components. You will likely cause more harm than good! Any moving parts are designed to operate for the life of the machine with no additional lubrication required.
A. CLEANING THE PUBLISHER
Use a clean,
Always disconnect your Publisher’s power cords before cleaning. Resume operation only after the surfaces are completely dry.
B. PERFORMING A ROBOTIC SELF-TEST
To ensure that everything is working properly, a
•Load some discs into the Input Bin
•Make sure the Publisher’s front cover is closed
•With the Publisher turned on, press the Cartridge Button
•While holding the Cartridge Button, press the
Power Button | until the robotics start to move. |
•Release both buttons
•To stop the test, wait until the disc has moved to the Output Bin and press the Power Button.
Maintenance and Troubleshooting 59