Getting Started
2.Orient the battery so that the two contacts on the battery will be face down, and will correspond with the two contacts inside the printer’s battery compartment, and set the battery into the compartment. A label showing this orientation is also located inside the battery compartment.
3.Close the battery door and slide the Battery Door Releases back to the locked position.
Charging the Battery
Insert the AC adaptor plug into the printer. The Yellow/Amber charging indicator will illuminate indicating that the battery is being charged.
After about 180 minutes the indicator will go off and the battery will be fast charged.
Note: You must charge the battery for 24 hours prior to the first use. Maximum battery capacity is reached after completing a minimum of three normal usage charge and discharge cycles.
Attaching The Belt Loop System
The belt loop system consists of two parts:
•A knob located on the back part of the printer just above the battery door
•A belt loop strap with a click on connector
After sliding your belt through the strap of the belt loop:
•Insert the knob located on the bottom of the printer into the slot of the belt loop connector.
•Pull down on the printer until you hear a click. The printer is now secure and can safely hang down beside your hip.
•To release the printer, press in on the two latches on the sides of the connector and pull the printer and knob up and clear of the slot.
Note: Do not force or pull the printer from the connector without pressing in on the two latches.
5
