Tip: Do not pinch the Wire Harness (100).
Start all screws before tightening any of
them. | Wire Tie |
|
Have another person hold the Upright (2) near the Frame (1). Locate the wire tie in the Upright. Tie the lower end of the wire tie to the Wire Harness (100). Next, pull the upper end of the wire tie upward out of the top of the Upright. Then, untie and discard the wire tie. Tip: To prevent the Wire Harness from falling inside
the Upright, secure the Wire Harness with a rubber band.
Attach the Upright | (2) to the Frame | (1) with four |
| ||
M10 | x 20mm Patch | Screws | (79), and four M10 | 79 78 | |
Split | Washers (78). Do not | tighten | the Patch | 78 | |
| |||||
Screws yet.
, Orient the Water Bottle Holder | (5) as shown | 4 |
|
and slide it onto the Upright (2). Attach the |
| ||
|
| ||
Water Bottle Holder with two M4 x 32mm |
|
| |
Screws (95). |
| Do not pinch | the |
|
| Wire Harness | (100) |
Tip: Do not pinch the Wire Harness (100).
Slide the Console Cover (96) onto the Upright
(2)and move it downward to the Water Bottle Holder. Then, insert the Console Bracket (3) into the top of the Upright. Attach the Console Bracket with four M4 x 16mm Screws (84).
Do not pinch the Wire Harness (100)
7
