11.At the same time, insert a Pedal Arm Axle (21) into the Right Upper Body Leg (31) and into the right Pedal Arm (14); make sure that the
Upper Body Leg Spacer (113) and the Pedal Leg Spacer (114) are in the indicated loca- tions.
Attach the Right Upper Body Leg (31) with an M6 x 16mm Patch Screw (80) and an M6 Large Washer (90).
Then, attach the right Pedal Arm (14) with an M6 x 16mm Patch Screw (80) and an M6 Large Washer (90).
Repeat this step for the other side of the elliptical exerciser.
See step 3. Tighten the four M10 x 20mm Patch Screws (79). Tip: Tighten the two Patch Screws on the front of the elliptical exercis-
er before tightening the other two Patch Screws.
12.Identify the Right Upper Body Arm (9), which is marked with a "Right" sticker. Orient the Right Upper Body Arm as shown; make sure that the hexagonal holes in the Right Upper Body Arm are in the indicated location.
11
113
14
21
114
12
Slide the Right Upper Body Arm (9) onto the
Right Upper Body Leg (31). Attach the Right
Upper Body Arm with two M6 x 38mm Button
Bolts (76) and two M6 Locknuts (77); make
sure that the Locknuts are inside the hexag- onal holes.
Repeat this step for the Left Upper Body | onal |
Arm (8) and the Left Upper Body Leg (6). | Holes |
13.Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser.
11
