11.Identify the Le'Itand Right Upper Body Arms (84, 85).

Make sure that the Left Upper BodyArm (84) is positioned as shown, Attach the Left Upper Body Arm to the Left Upright (66) with two 1!4" x 3 1/2" Screws (58), two t/4" Star Washers (23), and two 3/8" Star Washers (3) as shown. Do not overtighten the Screws.

Attach the Right Upper BodyArm (85) asde- scribed above.

12. Attach the

Latch

Housing

(67)

with

the Latch

12

Spacer

(82) to the

Left Upright

(66)

with

two

#10

x 1 1/2 _'Screws

(8}; make

sure that the

large

hole in

the

Latch

Housing

is on the indicated

side. Start

both

Screws,

and

then

tighten

 

them. Be careful not to overtighten the

Screws.

Locate the Latch Pin Assembly I88). Remove the knob from the pin, Make sure that the collar and the spring are on the pin. (Note: If there are two collars, place one on each side of the spring.) Insert the pin into the Latch Housing (67). Then, tighten the knob onto the pin.

Large

13.Make sure that all parts are properly tightened before you use the treadmill, If there are sheets of plas- tic on the treadmin decals, remove the plastic, To protect the floor or carpet, place a mat under the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt (see pages 21 and 22).

12

Page 12
Image 12
ProForm 831.24843.0 Attach Latch Housing With Spacer Left Upright Two, 1/2 Screws Make Sure that Large Hole Latch