ProForm 831.24843.0 user manual Symptom The incline of the treadmill does not

Locate the Reed Switch (33) and the Magnet (32) on the right side of the Pulley (31). Turn the Pulley until the Magnet is aligned withthe Reed Switch,

Make sure that the gap between the Magnet

and the Reed Switch is about 1/8 in. (3 mm). If necessary, loosen the #8 x 314" Truss Head Screw (14), move the Reed Switch slightly, and then retighten the Screw, Carefully slidethe Motor

Hood (not shown) back on by lining up the guides. Reattaeh the Motor Hood with the five #8 x 3/4"

Screws (not shown), Then, plug in the powercord,

insert the key, and runthe treadmill for a few min- utes to check for a correct speed reading,

118in.--_l--

@

SYMPTOM: The incline of the treadmill does not

change correetty

a.Hold down the Stop button and the Speed increase buttes, insert the key into the console, and then retease the Stop button and the Speed increase

button. Press the Stop button and then press the [ncline increase or decrease button. The treadmill

will automatically rise to the maximum incline level and then return to the minimum level. This will re-

calibrate the incliee sysfem. If the incline does not

. begin calibrating, press the Stop button again, and then press the Incline increase or decrease button again. When the incline is calibrated, remove the key from the console.

SYMPTOM: The walking belt slows when walked on

a.Use only a single-outtst surge suppressor thst meets all of the specifications described on page 13.

b.Ifthe walking belt is overtightened, treadmitl per- formance may decrease and the walking beIt may become damaged. Remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both idler roller screws counterclockwise, 1/4 of a turn. When the wal,king belt is propedytightened, you should be able to lift each edge of the walking belt 2 to 3 in. [5 to 7 cm) off the walking platform,Be careful to keep the walking beltcentered, Then, plug in the power cord, tnsed the key, and runthe treadmill for a few minutes. Repeat untilthe walk- ing belt is properlytightened,

Idler Relier Screws

c; Your treadmill features a walking belt coated with

high-performancelubricant.IMPORTANT:Never apply silicone spray or other substances to the walking belt or the walking pIatform unless in- structed to do so by an authorized service rep- resentative. Such substances may deteriorate the walking heft and cause excessive wear. tf yoususpectthat the walkingbelt needs morelubri- cant, see the front cover ofthis manual.

d.If the walking belt still slows when walked on, see the front cover of this manual.

21