ProForm 831.24843.0 user manual Assembly requires two persons, To identify small paris, see

ASSEMBLY

•Assembly requires two persons.

•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish assembly.

•The underside of the walking belt is coated with

high-pedormance lubricant. After shipping, there may be some lubricant on fop of the walking belt or on the shipping carton. This is normal. If there is lubricant on top of the walking belt, wipe it oN

with a soft cloth and a mild, non-abrasive cleaner.

•To identify small paris, see page 6.

•Assembly requires the following tools:

the included hex keys

one Phillips screwdriver

scissors8=_

• To avoid damaging parts, do net use power tools,

1.Make sure that the power cord is unplugged.

Remove and discard the two screws (A) and the shipping bracket (B) from the r_ghtside ofthe Base (74). 3"hen,remove and discard the screws and shipping bracket (not shown) from the left side of the Base.

2. With the help of a second person, tip the tread-

2

mill onto its left side. PaPally pivot the Base (74) to help stabUze the treadmill.

Pull the Upright Wire (63) and the ground wire through the indicated hole in the Base (74).

Attach the groundwire te the Base (74) with a#8 x 1/2" Ground Screw (1).

See the inset drawing, Cut the plastic tie near the Upright Wire (63). Be careful not to dam-

age the Upright Wire,

74

63