TROUBLESHOOTING
Most treadmill prob{ems can be solved by following the simple steps below. Find the symptom that applies, and follow the steps listed. If further assis- tance is needed, see the front cover of this manual
SYMPTOM: The power does not turn on
Make sure that the power cord is plugged into a surge suppressor and that the surge suppressor is
plugged into a
13. IMPORTANT: The treadmill is not compat-
ible with
compatible with
b.After the power cord has been plugged in. make sure that the key is inssded into the console.
Check the power switch located on the treadmill frame near the power cord. If the switch protrudes as shown, the switch has tripped. To reset the power switch, wait for five minutes and then press the switch back in,
TrippedReset
SYMPTOM: The power turns off during use
c.Remove the key from the consols, and then reinsert it.
d, If the treadmill still wilt not run, please see the front cover of this manual.
SYMPTOM: The console displays remain lit when
you remove the key from the console
a, 3he console features a display demo mode, de-
signed to be used if the treadmill is displayed in a
store. If the displays remain lit when you remove the key, the dome mode is turned on. To turn oil
the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE
INFORMATION MODE on page 18 to turn off the dome mode.
SYMPTOM: The displays of the console do not function properly
a.RemovethekeyfromtheconsolsandUNPLUG
THE POWER CORD. Next, remove the five indi- cated #B x 3/4" Screws (4).
a. Check the power switch (see the drawing above). If the switch has tripped, wait for five minutes and then press the switch back in.
b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug if, wait for five minutes, and then plug it back in.
Carefully lift the Motor Hood (48) upward_ and then slide it forward and off. Make sure that the Motor Hood does not get caught bythe tabs on Ibe sides of the Motor Hood.
2O
