ProForm PFANSY9825.1 Arm Assembly, Locknuts yet, Tighten the M8 Nylon Locknuts 91 used in steps

12.Attach the Left Top Frame (36) to the Right Top Frame (5) with four M8 x 78mm Bolts (82), two M8 Washers (98), a Support Plate (31), and four M8 Nylon Locknuts (91). Do not tighten the

Locknuts yet.

13.Attach the Left Top Frame (36) to the Left Upright (26) with two M8 x 78mm Bolts (82), a Support Plate (31), and two M8 Nylon Locknuts (91). Do not tighten the Locknuts yet.

14.Orient the Butterfly Frame (14) as shown. Attach the Butterfly Frame to the Right Upright (2) with two M8 x 72mm Bolts (85), two M8 Washers (98), and two M8 Nylon Locknuts (91). Do not tighten the Locknuts yet.

Attach the Butterfly Frame (14) to the Right Top Frame (5) with two M8 x 78mm Bolts (82), two M8 Washers (98), and two M8 Nylon Locknuts (91).

Tighten the M8 Nylon Locknuts (91) used in steps 3–14.

Arm Assembly

15.Wet the lower end of the Left Butterfly Arm (6) with soapy water. Slide a Large Foam Pad (15) onto the Left Butterfly Arm.

Note: an entire grease packet should be used for this step. Grease an M10 x 85mm Bolt (74) and the indicated edges of two Arm Bushing (23) with a grease packet. Attach the Left Butterfly Arm (6) to the Butterfly Frame (14) with the Bolt (74), an M10 Large Washer (100), the two Arm Bushings, and an M10 Nylon Locknut (90). Make sure the bolt head fits inside of the hole in the Butterfly Frame.

Repeat this step with the Right Butterfly Arm

(7).

12
	36	31	82
			98
91				82
		91		98
5		91
13			82
		36
			31
				91
		91		26
14		82	98
		98
		5
			91
98	91	91	2
		14
85
	98
15
7		74—Grease
			Grease
	14		23
		100
		90
		Grease	23	6
				15

10