ProForm PFANSY9825.1 user manual Cable Trap and Finger Guards are oriented as

27. Wrap the Press Cable (109) around a “V”-pulley	27		66
(62). Attach the “V”-pulley, two Half Finger Guards
(66), a Large Cable Trap (111), and an M10			99
Washer (99) inside the bracket on the Left
			62
Upright (26) with an M10 x 65mm Bolt (77) and
an M10 Nylon Locknut (90). Make sure the		77	109
Cable Trap and Finger Guards are oriented as	26
			111
shown.
			66
	90
28. Wrap the Press Cable (109) around a 90mm	28
Pulley (63). Attach the Pulley, two Half Finger
Guards (66), a Cable Trap (68), and an M10				66	90
Washer (99) to the Press Frame (29) with the		109	63
M10 x 135mm Bolt (70) used in step 26 and an
M10 Nylon Locknut (90). Make sure the Cable
Trap and Finger Guards are oriented as				68
shown.			99
			66
			29
		70
29. Wrap the Press Cable (109) under a 90mm	29
Pulley (63). Attach the Pulley, two M10 Washers
					66
(99), and two Half Finger Guards (66) inside the			63
bracket on the Left Base (25) with an M10 x
			99
50mm Bolt (64) and an M10 Nylon Locknut (90).					99
Make sure the Finger Guards are oriented as		66
shown.					64
			90		109
				25
30. Wrap the Press Cable (109) over a 90mm Pulley	30
(63). Attach the Pulley and a Cable Trap (68) to
		80	68
the Right Top Frame (5) with an M10 x 45mm
Bolt (80) and an M10 Nylon Locknut (90). Make			63
			5
sure the Cable Trap is oriented to hold the					90
Cable in the groove of the Pulley.
				109

14