9.Have another person hold the Console (17) near the Upright (2).
Connect the Upper Wire Harness (115) to the wire harness on the Console (17). Connect the Pulse Extension Wire (114) to the pulse wire on the Console. Next, locate the two ground wires that are attached with a screw to the Upright (2). Connect the ground wires to the two smallest wires on the Console.
Carefully insert all excess wiring up into the Console
(17)and down into the Upright (2). Attach the Console to the Upright with four M4 x 16mm Screws (98). (Note: The Screws may be shipped in the console box.) Be careful to avoid pinching the wires.
10.Plug the Power Cord (116) into the Power Socket
(117)at the rear of the elliptical exerciser.
9 | 17 |
|
Do not pinch |
| |
the wires |
|
|
during this step |
|
|
114 |
|
|
|
| 115 |
98 |
| Ground |
|
| Wires |
|
| 2 |
10 |
|
|
| 117 | 116 |
11.Make sure that all parts of the elliptical exerciser are properly tightened. Cover the floor beneath the elliptical exerciser to protect the floor from damage. Note: Some extra hardware may be left over.
10
