MAINTENANCE AND TROUBLESHOOTING
Inspect and tighten all parts of the exercise cycle reg- ularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a small amount of mild soap. Important: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight.
HOW TO MOVE THE EXERCISE CYCLE
To move the exercise cycle, stand behind it and lift the frame in the location shown below. To reduce the risk of injury, bend your legs and keep your back straight. As you lift the frame, make sure to lift with your legs rather than your back. Carefully move the exercise cycle on the front wheels, and then lower the frame.
Wheel |
Lift |
Here |
HOW TO LEVEL THE EXERCISE CYCLE
After the exercise cycle has been moved to the location where it will be used, make sure that
both ends of front stabiliser are
touching the floor. If the exercise cycle rocks slight-
ly during use, turn one or both of the leveling feet under the front stabiliser until the rocking motion is eliminated.
HANDGRIP PULSE SENSOR TROUBLESHOOTING
•Avoid moving your hands whilst using the handgrip pulse sensor. Excessive movement may interfere with heart rate readings.
•Do not hold the metal contacts too tightly; doing so may interfere with heart rate readings.
•For the most accurate heart rate reading, hold the metal contacts for about 30 seconds.
•For optimal performance of the handgrip pulse sen- sor, keep the metal contacts clean. The contacts can be cleaned with a soft cloth; never use alcohol, abrasives, or chemicals.
BATTERY REPLACEMENT
If the console is using battery power, and if the dis- plays becomes dim, the batteries should be replaced. Most console problems are the result of low batteries. See assembly step 12 on page 9 for replacement instructions.
24
