MAINTENANCE AND TROUBLESHOOTING
Inspect and properly tighten all parts of the exercise cycle regularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a small amount of liquid dish soap. Important: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight.
BATTERY REPLACEMENT
If the console display becomes dim, the batteries should be replaced; most console problems are the result of low batteries. To replace the batteries, see assembly step 12 on page 8.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, you must first remove the left side shield. Using an adjustable wrench, turn the left pedal clock- wise and remove it. Next, remove the screws from the left side shield. Note: There are different sizes of screws attaching the left side shield. Be sure to note the location of each screw. Then, carefully remove the left side shield.
With the left side shield removed, locate the Reed Switch (24). Turn the Crank (18) until the Magnet (19) is aligned with the Reed Switch. Next, loosen, but do not remove, the indicated Reed Switch Screw (49). Slide the Reed Switch slightly closer to or away from the Magnet, and then retighten the Screw. Turn the Crank for a moment. Repeat until the console dis- plays correct feedback. When the Reed Switch is cor- rectly adjusted, reattach the left side shield and the left pedal.
View From Front |
24 |
18 |
49 |
19 |
HANDGRIP PULSE SENSOR TROUBLESHOOTING
If the handgrip pulse sensor does not function properly, see step 5 on page 13.
17
